By
podtor
Cześć, potrzebuję Waszej fachowej pomocy z routerem Netgear R8000. Podczas uruchamiania routera w konsoli TTL pokazuje zamiast tekstu tylko 0x0E 0x0E 0x0E przez 80% czasu, pod koniec uruchamiania (które trwa z 5 minut) wyrzuca trochę tekstu na konsole
console [ttyS0] enabled, bootconsole disabled
serial8250.0: ttyS1 at MMIO 0x18000400 (irq = 117) is a 16550
brd: module loaded
loop: module loaded
pflash: found no supported devices
bcmsflash: found no supported devices
Boot partition size = 524288(0x80000)
lookup_nflash_rootfs_offset: offset = 0x200000
nflash: squash filesystem with lzma found at block 29
Creating 5 MTD partitions on "nflash":
0x000000000000-0x000000080000 : "boot"
0x000000080000-0x000000200000 : "nvram"
0x000000200000-0x000004200000 : "linux"
0x0000003b4dbc-0x000004000000 : "rootfs"
0x000002200000-0x000002240000 : "board_data"
PPP generic driver version 2.4.2
PPP MPPE Compression module registered
NET: Registered protocol family 24
PPTP driver version 0.8.5
...
i mam dostęp do routera ale router jest w jakiś dziwnym trybie czyli działa tylko w konsoli TTL.
Macie jakiś pomysł o co tu chodzi i jak go przywrócić do normalnej pracy?
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.